7 Way Connector- Female

$20.02

Inner cavity sealed to prevent contaminants from passing to wire harnessNon-corrosive housing: resists magnesium chloride, salt, oils, grease, and fuelsExtended front barrel for additional cable support, slanted 5° for moisture...
Inner cavity sealed to prevent contaminants from passing to wire harness
Non-corrosive housing: resists magnesium chloride, salt, oils, grease, and fuels
Extended front barrel for additional cable support, slanted 5° for moisture drain
Meets SAE J560 specifications
Split brass pins for superior conductivity
For solid pin sockets, please contact customer service

DATA SHEET:

Manufacture Phillips Industries
Material Polycarbonate


MORE INFO:

  • 16-722, and 16-7222 accepts #8 ring terminals
  • 16-724, and 16-725, and 16-7242 accept .180 bullets
  • 16-724 and 16-7242 recommended for use with Phillips QCS2™
  • For added protection against moisture, use socket boot P/N 15-740

Dust or wipe clean with a cloth dampened with water once a week. Be sure not to leave water spots on the surface. These water spots will dry and could possibly leave permanent marks. Clean stains/spots using the following steps: Dampen a soft cloth with a mixture of hot water and liquid dishwashing detergent. Wring the cloth as much as possible to remove excess liquid. Rub the surface lightly in a circular motion. Dry the surface immediately with a clean, soft towel.